Mestra M-9 Polymerizer

Programmable curing unit constructed completely of stainless steel. Fits up to 9 flasks with clamp 030390.

The M-9 polymerizer is equipped with a processor to change temperature according to a pre-set program.

On the M-9 the operator (user) can select the following:

• A delayed start time set in hours and minutes from 0.00 to 99 hours 59 minutes. This means the program can be pre-set to start at a specific time. The delay works every time the program is initiated.
• The duration of each temperature increase gradient in hours and minutes from 0.00 to 99 hours 59 minutes.
• The desired holding time in hours and minutes from 0.00 to 99 hours 59 minutes at each plateau.

END OF TREATMENT WARNING BUZZER

When the program completes treatment a modulated warning buzzer is set off for one minute. When the alarm buzzer sounds, press any key to acknowledge the alarm and continue the program.

• If the power fails the regulator stores all its data, and when power returns it continues from the same point in the program.
• Programs and parameters are stored indefinitely when power to the regulator is cut off.

Specifications